3D HeroQuest board

[sajungzak]

another option

[Sandman0077]

My concern with that is that I might have to change the location of the door if its too large to go where the quest dictates. The Zealot doors look to be the solution. I'd have to rebase them, but that shouldn't be an issue. Can someone post a picture of them with the board or minis?

[Sandman0077]

Got some more molding and gluing done tonight.

Accessories:


Room tiles starting to take shape:

[Daedalus]

The Hirst molds are terrific. The small air bubbles you see are my own fault, not a reflection of his quality. As far as homemade molds go, I will have to make my own for the different room tiles. I am thinking I can just modify the uncracked tiles to show the floor patterns but I'm not sure. I don't feel comfortable recasting his tiles so I might just start fresh with a 1x1 wooden tile and go from there....

Some folks at HQ-Cooperation made their own molds for the floor tiles that they are willing to sell. If you haven't already, check out HQ-Modular for ideas or contact information.

[Sandman0077]

Just a quick look at the overall progress of the board. Looks a bit thin, but keep in mind that the wall sections will be empty.

[Yochanan]

I'm super jealous - this is looking amazing. Keep up the great work.

[Maike05]

looks like tetris xD

[Thantos]

My concern with that is that I might have to change the location of the door if its too large to go where the quest dictates. The Zealot doors look to be the solution. I'd have to rebase them, but that shouldn't be an issue. Can someone post a picture of them with the board or minis?

Will soon have a mould for open doors only too, so wont need to buy 1:1 open closed anymore

Progress looking good so far

[Sandman0077]

My concern with that is that I might have to change the location of the door if its too large to go where the quest dictates. The Zealot doors look to be the solution. I'd have to rebase them, but that shouldn't be an issue. Can someone post a picture of them with the board or minis?

Will soon have a mould for open doors only too, so wont need to buy 1:1 open closed anymore

Progress looking good so far

I honestly think those doors are too wide as well. I'm just going to have to go with my 0.5" wall spacer idea. Oh well.

Started working on some different wall types tonight. Here are some sewer drain ideas I had:

[Thantos]

I honestly think those doors are too wide as well. I'm just going to have to go with my 0.5" wall spacer idea. Oh well.

That's cool going with spacers, but i feel i must defend the doors since I did spend some time getting them exactly right, calculating my prototype's deviation from digital input and resin shrinkage based upon cast thickness when casting from silicone moulds (-1.14% if I recall correctly). The HQ card door is 28.92mm wide and the resin one is 29.15 mm wide at the widest point of the doors. So that's a 230micron wider dimension, which is only because the edges are rough stone and im measuring from the widest point.

I like the sewer drains, shares in dental stone are going to go up because of you