Ye Olde Inn

I’m converting my old school Heroquest set to 3D printed miniatures. I’ve finished the base game figures, furniture, tokens and dice and have started on expansions.

I found an Ogre Warrior figure (MotM, AtOH) and printed 4 before noticing that this particular STL doesn’t have a base.

Can anyone please suggest an STL of just the ogre-sized base that I can print and glue on?

Thanks!

I couldn't find what I was looking for so I improvised.

I took another Ogre STL that had a base and inverted it in the Slicer software, then sank it beneath the plate so just the base was above the plate. I duplicated it several times and printed enough for the four Ogres I had without bases.

Hope this helps someone else.