by Kurgan » Sunday October 24th, 2021 11:15am
Sure. The plan is to take it to a print shop to print on glossy (or satin finish) sticker sheet paper. My glue stick glue doesn't adhere very well to this plastic, and I didn't want to use super glue. Not sure about the timing, but I'll document the results!
They sell these bamboo skewers around here pretty cheap that are just about the right size to fit into the flag pole holes, so I think I will use some of those (trimmed to length) for the "missing" flags. No need even to paint them since the originals would have been tan colored.
Since I don't want to ruin any existing bases, I may just print the "unit labels" and stick them to card stock (folded like little "table tents") so they can easily go over existing name plates. Sure, it won't be like I have new units, but variety in the existing ones, substituting different values as I see fit for new battles.
It probably wouldn't be too hard to 3d print new unit bases, even easier than the miniatures, if there's a decent scan. Having a few blank generic ones would be kind of neat. But could have maybe two shades of green, for special extra units (right now the only extras I have are some wolves... three spares after I've mounted up the rest with goblins).