Pancho wrote:I love that knight. Is he HQ scale?
Like I said, I think so. You may want to scale him down as he appears to be 1/2 a head taller than the Barbarian but lines right up with the GW Chaos Warrior .
Also if you are planning on printing, please check out my "Make" on Thingiverse for my printer settings. The secret is small layers and taking it slow. It has also been pointed out that 100% infill achieved by calling every layer a "top layer" (e.g. 99999) top layers in Cura gives the highest quality. Of course you will wait 7.5 hours for the model. But I think it was worth it.
Here it is before paint (and final clean-up).
As my first print, I ended up tossing him across the room and breaking his sword when removing him from the platform. But it glued back on very well. If I were printing a bunch of these, I would cut the sword and helmet fins off, and print them separately. I have not optimized the setting on my printer and it is likely I need a higher temperature to prevent the stringing... and maybe different retraction settings. With results like these, I'm not going to bother.
Good Luck!