HeroQuest 3D printing models (.stl files)

[Daedalus]

[This topic was moved from Board index ‹ Special Rooms ‹ Miniature Exchange Room on 3/17/18. A similar topic from Board index ‹ HeroQuest Rooms ‹ General HeroQuest Discussion was merged on 3/19/18.-edit]

I hate online forums.

https://springer3dscans.wordpress.com/2 ... -game-set/

[Vega]

I hate online forums...

https://springer3dscans.wordpress.com/2 ... -game-set/

[neocorps]

Hi,

I have just uploaded a Closed door STL file if you are interested.

https://www.thingiverse.com/thing:2754469

Feel free to comment and tell me if you are having problems. Cheers.

[cartmann2]

Thank you! I'll try it out and then I post here the results!

[Big Bene]

There's already a thread abut those.
If you hate forums, why bother posting here?

[lestodante]

I know the quality of those scans are not so detailed...

[Big Bene]

These models were presented at the Inn by the creator and already discssed thoughoutly:
http://forum.yeoldeinn.com/viewtopic.php?f=143&t=3827&hilit=springer3dscans

[Daedalus]

I hate online forums.

https://springer3dscans.wordpress.com/2 ... -game-set/

Thanks for taking the trouble to share your work with us. Too bad forums aren't your thing because we really have a great community here for sharing Hero Quest interest.

I only possess a layman's understanding of 3D scanning and printing. What would you say is the percentage of lost detail on a printed figure? I imagine there is some variability, as deeper cuts in small areas and slight contours tend to fill in a bit. Regardless, your project is promising and I hope to see files of rarer expansion figures one day.

[Daedalus]

Hi,

I have just uploaded a Closed door STL file if you are interested.

https://www.thingiverse.com/thing:2754469

Feel free to comment and tell me if you are having problems. Cheers.

More doors is good--thanks!